$31.85This product compliments the Verus billet clutch fork with a stronger pivot point as well. Machined from pre-hardened stainless steel, this clutch fork pivot is significantly stronger and more durable than the factory unit. Simple bolt on operation, remove the old unit, replace it with this reinforced unit.an support pressures up to 1,000 pounds.
$1,175.00Reduce drive line slack and rotational weight by over half with our lightweight carbon fiber driveshaft. Frequency balanced, strict carbon to epoxy ratio, and tested to 5000nm (3600+ft.lbs) of torque! Verus CF Driveshaft Weight is ~11lbs. Stock is 24.2lbs
$192.45Increase strength and longevity of the clutch fork by using our forged 4130 clutch fork for the FR-S, BRZ, and GT86. The ZN6/ZC6 chassis has a weak clutch fork that tends to break or bend when used with heavier pressure plates. This fork fixes those issues and can be used with extremely heavily sprung pressure plates. These are heat treated to a hardness of 26-32 HRC and then cyro treated for improved physical properties. The unit is black oxide coated for rust resistance. Note: Does not include pivot or throw out bearing, this is for the clutch fork only. Check out our strengthened pivot as well!